I really don't post to forums usually but this small question or discussion about memory usage i just had to post :shifty:
I have been using new CZDC++ (0.666 M-SE) for some weeks now and noticed that the memory usage is LOW compared to other clients.
Tested McDC++ and DC++ (0.674) and it used ~15MB when not connected to hubs and no uploads / downloads of course, running.
Then checked CZDC++ memory usage and it is a bit over 2,5MB when connected to one hub and one upload running.
Is the code just that much optimized in CZDC++? Any other possible reasons? Am i drunk?
(I'm not drunk really.)
Anyway PPK, keep up the good work with PtokaX and CZDC++.
Best client and hubsoftware out there.
Your praise is welcome. BTW there is a Praise @ Complaints section as well. ;)